Battery Pack Tester
| Parameters | |
| Test medium: |
Compressed air or specified medium by customers
|
|
Gas source:
|
0.4-0.8MPA (clean, dry) |
|
Power supply:
|
AC220V(±15%),50HZ,ground lead |
|
Environmental temperature:
|
0-50℃ |
|
Environmental humidity
|
≤95% (not dew)
|
|
Pressure adjustment range:
|
0-3Mpa |
|
Number of test ports:
|
1 |
| Status of the tested product | With or without hole, finished or semi product |
| Pressure mode: | Positive and negative pressure |
| Pressure regulation accuracy: | 0.05%F.S/0.02%F.S (Full range accuracy optional) |
| Sensor selection range: | 0-10kPa |
|
Sensor precision:
|
0.1%FS |
| Pressure minimum setting unit: | 1Pa |
| Resolution ratio: | 1Pa |
| Dimension: | 335*305*285mm |
| Gross weight: | 11KG |
SLA leak test detector is mainly used for scientific experiments in the laboratory or for the full inspection of the product in the production line. It can be independently used as a testing station, operated manually; or fused with the automatic line body to become one of the testing stations, which can be operated automatically. The leak detector takes clean and dry compressed air as the detection medium, and through a series of automatic detection, analysis and calculation processes, such as pressure sensor, precision pressure regulating valve, calculation unit and so on, the determination of the good and bad of the tested products is completed.
SLA leak test detector has the function of automatic calculation, automatic learning, automatic calibration, also with bar code scanning, remote control and other functions, real achieved the intelligence and simplification.
In the process of actual production and scientific experiment, instead of the traditional method of actual water bubble test and pressurized water bubble, the advantages of non-destructive, fast, data-based and scientific in testing process and results are realized.
The passive execution standard of SLA leak test detector is based on the actual test data and experimental test results to support each other, so must not be misled, or into misunderstanding.
SLA leak test detector allows only a positive misjudgment. That is, products that fall within the critical point of the criteria may be judged as bad, but they will never be qualified. (The critical point of evaluation criteria is theoretically eternal, so need to be upgraded to minimize critical mass in actual production)
LEAK TESTING is an important quality control test in the manufacturing industry. Since there is no such thing as a completely leak-free component, the key is to determine what leak rate is acceptable in order to manufacture products that are safe and adequate for the customer’s needs.
